This entry was posted on Friday, July 31st, 2009 at 11:13 am and is filed under PCB FAQ. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.
PCB Blog
All about PCB
Quick Flashing Red Light On Boiler Hotwater Tap Indicator?
Its a Worchester 24cdi. Had the Pcb board replaced a couple days ago. Just today, the light indicator for the Hotwater flashes quickly, when I go to reset it, the flashing stops for about an hour, then the flashing starts up again after an hour. All the other indicators are Fine.
One Response to “Quick Flashing Red Light On Boiler Hotwater Tap Indicator?”
Leave a Reply
One Response to “Quick Flashing Red Light On Boiler Hotwater Tap Indicator?”
-
Dr. Strangelove Says:
July 31st, 2009 at 5:49 pmIt’s trying to tell you something is wrong. Call your dealer since the repair should be under warranty.
Leave a Reply
Categories
- PCB Books (1)
- PCB Design (1)
- PCB FAQ (1455)
- PCB General (10)
- PCB News (8)
- PCB Softwares (6)
July 31st, 2009 at 1:07 pm
It’s trying to tell you something is wrong. Call your dealer since the repair should be under warranty.